Table of Contents
Advertisement
6300
POWER
LAN LINK
LAN ACT
WAN LINK
VOICE
POWER
LAN LINK
LAN ACT
WAN LINK
VOICE
POWER
LAN LINK
LAN ACT
WAN LINK
VOICE
Using the
WAN Con-
figuration
Menu
2000-A2-GB20-10
JF2304
SDSL with Frame Relay
JF2308
1. Set the datalink protocol to Frame Relay (page 53)
JF2316
2. Configure SDSL (page 64)
3. Configure DLCIs (page 86)
4. Configure Frame Relay options (page 90)
5. Configure the voice path (page 127)
SDSL with ATM
1. Set the datalink protocol to ATM (page 53)
2. Configure SDSL (page 64)
3. Configure PVCs (page 75)
4. Configure ATM (page 84)
5. Configure the voice path (page 127)
JF2304
To configure the physical interface of the IADs, you may also
use the Quick Configuration command. For more information,
see Quick Configuration on page 95.
JF2104
G.SHDSL with ATM
JF2104i
1. Set the datalink protocol to ATM (page 53)
JF2108
2. Configure G.SHDSL (page 64)
3. Configure PVCs (page 75)
4. Configure ATM (page 84)
5. Configure the voice path (page 127)
SDSL with ATM
1. Set the datalink protocol to ATM (page 54)
2. Configure SDSL (page 64)
3. Configure PVCs (page 75)
4. Configure ATM (page 84)
5. Configure the voice path (page 127)
Configuring the IAD for data involves several tasks. Tasks in this chapter
are described beginning at the WAN Configuration menu (which varies,
based on the WAN interface and datalink protocol).
Figure 4–3. WAN Configuration Menu
**************************************
WAN Configuration Menu
**************************************
Configuring T1/E1
1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure DLCIs
4. Configure FR Options
- 52 -
The IAD displays
the physical
interface in this
status message.
These options change,
based on your choice
of datalink protocol
February 2004
Advertisement
Table of Contents
