Showing Current Pvcs; Configuring Atm Options - Paradyne JetFusion Integrated Access Device User Manual

Configuring
ATM
Options
2000-A2-GB20-10
To delete the PVC, type Y, or cancel the deletion by typing any other
character.
3. The IAD saves the configuration and displays the PVC Configuration
menu where you may continue with other PVC management tasks.
4. Reset the IAD (page 14) when you finish PVC configuration.

Showing Current PVCs

To display a list of current PVCs, type 4.
The IAD displays the port list with associated PVCs:
Port VPI VCI
1 0 40 RFC 1483 (with LLC Encapsulation) 3641
2 100 39 RFC 1483 (with LLC Encapsulation
Maximum PCR this interface can support = 4830 cps
When you're done viewing the list, press any key to return to the ATM PVC
Configuration menu.
To configure ATM options, type 4 to display the ATM Configuration menu:
Figure 4–54. ATM Configuration Menu
*****************************************
ATM Config Menu
*****************************************
1. Configure Payload Scrambling
2. Configure F4 OAM VPI
3. Configure F4 OAM Type
4. Display F4 OAM Configuration
5. Send OAM Loopback
6. Configure EmptyCells
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the ATM
Configuration menu.
‹
Configuring Payload Scrambling (following)
‹
Configuring F4 OAM VPI (page 85)
‹
Configuring F4 OAM Type (page 85)
‹
Displaying F4 OAM Configuration (page 86)
‹
Sending OAM Loopback (page 86)
‹
Configuring EmptyCells (page 86)
Configuring Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling.
To enable or disable payload scrambling:
- 84 -
Encapsulation Type
Total = 3645 cps
PCR Service
UBR
4 CBR
--------
February 2004