Table of Contents
Advertisement
Using the
Debug
Menu
2000-A2-GB20-10
The Debug menu contains commands to set various debugging options.
Debugging should only be enabled specifically during a debugging or
monitoring session, and disabled when the session is complete. Enabling
multiple debugging options simultaneously slows IAD performance.
NOTE
Debugging commands are reserved for use by Paradyne
network engineers.
Debugging options may be enabled and disabled without resetting the
IAD. To display the Debug menu, type G on the Utilities menu.
Figure 3–9. Debug Menu
***************************************************
Debug Menu
***************************************************
M. Set Ethernet MAC
E. Enable/Disable PPP debug mode
S. Enable/Disable STP debug mode
I. Enable/Disable DHCP Client debug mode
Q. Display Error Dump
To perform a task, type the option and proceed to the appropriate section,
following.
Setting the Ethernet MAC Address
To modify the Ethernet MAC address, perform these steps:
1. Type M on the Debug menu. The IAD displays the following message:
This will change the factory setting for the ENET
Mac Address.
Are you sure?
2. Type Y to proceed, or any other character to abort.
When you proceed, the IAD displays the current MAC address for the
Ethernet port and prompts for a new one:
Current Ethernet Address= 00-E0-75-1C-0E-18
New MAC Address
3. Type the new MAC address. Press Escape any time to abort this task.
4. Reset the IAD (page 14) for the new MAC address to take effect.
Enabling and Disabling PPP Debug Mode
When you enable PPP debugging, the IAD displays PPP debug
messages. To enable or disable PPP debugging, follow these steps:
1. Type E on the Debug menu. The IAD displays the PPP debug status:
PPP Debug Mode is currently DISABLED
2. Type E to enable PPP debugging, or type D to disable it.
The IAD sets PPP debug mode to the setting you entered, and displays
the Debug menu.
- 41 -
= *-**-**-**-**-**
February 2004
Advertisement
Table of Contents
