Paradyne JetFusion Integrated Access Device User Manual page 133

2000-A2-GB20-10
When you're done viewing the details, press any key to return to the IP
Filter Copy to Buffer menu.
Table 5–2. Filter Details
Parameter
num
state
action
srcLwP
srcHiP
source.ip.addr.low
source.ip.addr.high
proto
mask
dstLwP
dstHiP
dest.ip.addr.low
dest.ip.addr.high
Editing a Filter in the Buffer
To edit a filter currently stored in the buffer, follow these steps:
1. On the IP Filter Copy to Buffer menu, type E to edit the filter.
2. Follow the IAD messages to enter values (page 112).
3. When you enter the last parameter, the IAD displays the summary
information and saves the configuration. The IAD displays the IP Filter
Configuration menu.
4. Continue with other configuration tasks, or press Escape to return to
the Router Configuration menu.
5. Reset the IAD (page 14) when you finish IP filter configuration.
Deleting a Filter from the Buffer
To delete a filter currently stored in the buffer, type X.
The IAD deletes the filter from the buffer and displays the IP Filter
Configuration menu.
- 114 -
Description
number of the filter
Idle or Active
Pass or Discard
Filter Source Port Low—TCP or UDP packets
only
Filter Source Port High—TCP or UDP packets
only
Filter Destination IP Low Address
Filter Source IP High Address
Filter protocol—IP, ICMP, IGMP, TCP, UDP
ICMP or TCP only
Filter Destination Port Low
Filter Destination Port High
Filter Destination IP Low Address
Filter Destination IP High Address
February 2004