Table of Contents
Advertisement
Bridge Sta-
tus Report
PPP Autho-
rization
Entries
Report
2000-A2-GB20-10
Table 12–28.Bridge Forwarding Database Report
Parameter
Port
Timer
You must enable bridging for this table to display. For more information on
enabling bridging, see
To display information about bridging, type S on the Reports Menu. The
IAD displays a record for each interface:
Table 12–29.Bridge Status Report
Parameter
Interface
Port
Spanning Tree Protocol (STP) enabled | disabled
State
Root
Designated
Timers
The spanning state timer value is for listening or learning states and
counts down from the forward delay time to zero.
The hello timer value is valid only if the active port is the Root Bridge of the
network. It counts down from the hello time to zero.
‹
Root priority—priority of the root bridge on the network.
‹
ID—Ethernet MAC address of the root bridge on the network.
Press any key to return to the Reports menu.
Type P on the Reports menu to display information about PPP
authorization entries. If no PPP authorization entries have been created,
the IAD advises you by displaying this message:
No PPP Authorization Entries Configured.
- 218 -
Description
Port for the Ethernet interface
No. of seconds until this entry deletes from the
database. The time counts down from the
bridge database aging time value, in one-
second intervals; at zero, the entry deletes from
the database.
Bridge Configuration
on page 118.
Description
interface for the active slot for bridging
port for the preceding interface
Spanning tree state: disabled | blocking |
listening |learning | forwarding
root port for the bridge—yes | no
designated port for the bridge—yes | no
current values of the spanning state timer (first
value) and the hello timer (second value)
February 2004
Advertisement
Table of Contents
