Basic Voice Path Setup Tasks - Paradyne JetFusion Integrated Access Device User Manual

Basic Voice
Path Setup
Tasks
2000-A2-GB20-10
After you have defined the voice PVCs or DLCIs on the IAD, you should
configure the voice path for voice operation to function correctly.
This chapter contains the following topics:
‹
Basic Voice Path Setup Tasks (page 127)
‹
Voice Path Configuration Menu (page 127)
‹
Setting the Voice Gateway (page 128)
‹
Setting Jitter Delay (page 130)
‹
Setting Start Mode (page 130)
‹
Setting SLIC Control Mode (page 132)
‹
Setting Compander Mode (page 132)
‹
Setting On Hook Transmission Mode (page 133)
‹
Setting Idle Voltage Mode (page 133)
‹
Setting Debug Mode (page 134)
‹
Configuring Echo Cancellation (page 134)
‹
Setting Loop Gain (page 135)
‹
Setting Country Mode (page 137)
NOTE When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.
To configure voice path settings, you should complete the following tasks:
‹
Select a voice gateway (page 128)
‹
Set the jitter delay (page 130)
‹
Set start mode (page 130)
‹
Set Compander mode (page 132)
‹
Set echo cancellation (page 134)
‹
Set loop gain (page 135)
‹
Set bandwidth tone (page 137)
- 127 - February 2004