Table of Contents
Advertisement
POWER
LAN LINK
LAN ACT
WAN LINK
VOICE
Managing
MGCP
Embedded
Client
2000-A2-GB20-10
When you select a specific country mode, the values are set automatically:
JF2008
Ring frequency and impedance settings are automatically
JF2104
applied to the JF2008, JF2104 and JF2108.
JF2108
Figure 7–11. Country Mode Selection Menu
*******************************************
Country Mode Selection
*******************************************
Current Country Name is ETSI Generic
Current Country Mode is Europe
A. Australia Complex Impedance
B. ETSI Generic
C. United States of America
1. Type the letter corresponding to the country mode you want to set.
2. The IAD saves the mode you've selected and displays the menu.
3. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
4. Reset the IAD (page 14) when you finish voice path configuration.
NOTE
To add support for any of the countries/regions listed above
but not displayed in the Country Mode Selection menu,
contact your service provider to obtain the file.
This section applies to MGCP—Voice Over IP—gateway management.
The IAD only displays option O, Manage MGCP Embedded
NOTE
Client on the Main menu if you selected Voice Over IP via
MGCP 0.1/NCS 1.0 or MGCP 1.0 as the Voice Gateway.
To configure or manage MGCP/NCS, type O to display the MGCP
Management menu:
- 138 -
February 2004
Advertisement
Table of Contents
