Table of Contents
Advertisement
Using the
Diagnostics
Menu
POTS
Diagnostics
2000-A2-GB20-10
Diagnostic tasks are all displayed and accessed on the Diagnostics menu
(displayed by typing Z on the Main menu). Tasks in this chapter are
described beginning at the Diagnostics menu.
Figure 14–1. Diagnostics Menu
*******************************************
Diagnostics Menu
*******************************************
P. POTS Diagnostics
S. SDSL Diagnostics
B. ISDN-BRI Diagnostics
NOTE
Option S (SDSL Diagnostics) is available only on SDSL-
equipped IADs: JF2304 and JF2308. Option B (ISDN-BRI
Diagnostics), is available only on the JF2004i and the
JF2104i.
You may sign on as Supervisor or Network Manager to perform
diagnostics tasks. Options that display in the Diagnostics menu are the
same for both security levels. Type the option and proceed to the
corresponding section.
A WAN uplink is not required to perform POTS testing. To perform POTS
diagnostics type P on the Diagnostics Menu.
The IAD loads and configures the DSP software module, and displays the
following menu:
Figure 14–2. POTS Diagnostics Menu
*******************************************
POTS Diagnostics
*******************************************
D. Dialup Test
H. Hotline Test
R. Ring Test
S. Power Supply Test
P. Phone Detect Test
R. Ring Test
O. On/Off Hook Test
I. Infineon Codec Test
- 237 -
February 2004
Advertisement
Table of Contents
