Setting Slic Control Mode; Setting Compander Mode - Paradyne JetFusion Integrated Access Device User Manual

Setting
SLIC Con-
trol Mode
Setting
Com-
pander
Mode
2000-A2-GB20-10
To set SLIC control mode (for POTS only), type T to display the SLIC
Control Mode Selection menu:
Figure 7–5. SLIC Control Mode Selection Menu
*******************************************
SLIC Control Mode Selection
*******************************************
Current Control Mode = AUTO Control Mode
A. AUTO Control Mode
B. MANUAL Control Mode
Type the option of the control mode to set.
1. The IAD saves the mode you've selected and displays the menu.
2. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
3. Reset the IAD (page 14) when you finish voice path configuration.
NOTE Voice gateway applications, such as CopperCom or
JetStream, overrides the value set by this command.
To set Compander Mode, type U to display the Compander Mode
Selection menu:
Figure 7–6. Start Mode Selection Menu
*******************************************
Compander Mode Selection
*******************************************
Current Compander Mode = u-Law
U. u-Law Mode
A. A-Law Mode
1. Type the option of the Compander mode to set.
2. The IAD saves the mode you've selected and displays the menu.
3. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
4. Reset the IAD (page 14) when you finish voice path configuration.
NOTE If you are unsure which mode to use, check with your
telephone service provider. Normally, u-Law is used in North
America and a-Law is used in Europe.
- 132 - February 2004