Table of Contents
Advertisement
2000-A2-GB20-10
Type the port number corresponding to the DLCI you want to set to
real-time.
3. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
4. Reset the IAD (page 14) when you finish Frame Relay configuration.
Configuring the Maintenance Protocol
To configure the maintenance protocol:
1. On the Main menu, select Configure WAN to display the WAN
Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
(page 90).
3. Select Configure Maintenance Protocol to display the Frame Relay
Maintenance Protocol menu.
Figure 4–64. Frame Relay Maintenance Protocol Menu
*****************************************
Frame Relay Maintenance Protocol
*****************************************
0. None
1. CCITT Q.933 Annex A Network
2. CCITT Q.933 Annex A User
3. CCITT Q.933 Annex A Both
4. ANSI T1.617 Annex D Network
5. ANSI T1.617 Annex D User
6. ANSI T1.617 Annex D Both
7. LMI Network (FRF.1.1)
8. LMI User (FRF.1.1)
9. LMI Both (FRF.1.1)
4. Type the number that corresponds to the protocol on your network and
press Enter.
5. Reset the IAD (page 14) for changes to take effect.
Configuring the Congestion Parameters
To configure the congestion parameters:
1. On the WAN Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
(page 90).
3. Select Configure Congestion Parameters to display the FR Congestion
Configuration menu.
Figure 4–65. Frame Relay Congestion Configuration Menu
*****************************************
*
FR Congestion Configuration
*****************************************
1. Configure Transmit Congestion Parameters
2. Configure Receive Congestion Parameters
- 93 -
*
February 2004
Advertisement
Table of Contents
