Table of Contents
Advertisement
2000-A2-GB20-10
Figure 4–33. Configure S-Bits Menu
*******************************************
Configure S-Bits Menu
*******************************************
Current S-Bit Configuration:
Sa4 Bit
Sa5 Bit
Sa6 Bit
Sa7 Bit
Sa8 Bit
2. Toggle Sa4 Bit
3. Toggle Sa5 Bit
4. Toggle Sa6 Bit
5. Toggle Sa7 Bit
6. Toggle Sa8 Bit
3. To toggle a given bit, type the corresponding option number.
4. The IAD saves the configuration and displays the menu.
5. Continue setting S-bits. When you've finished, press Escape to return
to the E1 Configuration menu and continue configuration tasks.
6. Reset the IAD (page 14) when you finish E1 configuration.
Configuring the Transmit and Receive Channels
Type 5 to select Configure Transmit Channels, or type 6 to select
Configure Receive Channels.
The IAD displays a message indicating the number of channels enabled,
and displays the Channel Configuration menu.
Figure 4–34. Channel Configuration Menu
Tx Channels Enabled = No Channels Enabled.
************************************
Channel Configuration Menu
************************************
*
1. Enable All Channels
*
2. Disable All Channels
*
3. Select Individual Channels *
*
4. Select Channel Range
*
*
Esc To Return To Previous menu *
************************************
For each option, proceed to the corresponding section.
Enabling or Disabling All Channels
1. Type 1 to enable all channels. Type 2 to disable all channels.
2. The IAD makes the change and resets the interface. (The menu and
reset messages may conflict—press any key to refresh the menu.)
- 73 -
= Cleared
= Cleared
= Cleared
= Cleared
= Cleared
*
*
*
*
February 2004
Advertisement
Table of Contents
