Unpacking The Iad; Installing The Iad - Paradyne JetFusion Integrated Access Device User Manual

Unpacking
the IAD
Installing
the IAD
POWER LAN LINK LAN ACT WAN LINK VOICE
POWER LAN LINK LAN ACT WAN LINK VOICE
2000-A2-GB20-10
Each IAD is packed and shipped in a durable container. If you haven't
already done so, open the container and unpack the IAD. Carefully
remove the IAD from the package and packing material.
IAD Package Components
Each IAD is shipped with the components listed below. As you unpack
them, note their condition and identity, and compare the list to the packing
list in the package.
‹
AC power adapter and cord (6 feet long), or AC power cord
‹
Agency Compliance information sheet
‹
Ethernet cable (straight through), 7 feet long
‹
WAN cable (varies by interface), 7 feet long
If you note any visible damage, or components are missing, notify the
shipping company immediately to make a damage claim. Contact the
company from which the IAD was purchased to obtain a Return Material
Authorization (RMA) for return of damaged equipment, or to order missing
components.
NOTE We suggest you keep the shipping container and packing
material for future shipping or storage of the unit.
After you unpack the IAD, find a suitable location to install the IAD in the
customer's premises. Ideal locations include computer equipment room, or
a telephone or wiring closet. You can locate the IAD in an equipment rack,
on a table or shelf, or it may be wall-mounted. Install the IAD in a location
that is generally protected and the IAD will be undisturbed.
AC Power and Uninterruptible Power Supply
The IAD requires access to AC power (NEMA 15-3R). Make sure the IAD
is located within six feet of an AC power outlet. Locate the nearest power
outlet and plug in the supplied AC power adapter or AC power cord. If
there is an uninterruptible power supply on premises, plug the AC power
adapter or cord into that power source.
Ensure that the power cord conveniently and safely reaches the rear panel
of the IAD where the power plug or adapter jack is located.
2/4/8-Port Do not attach the AC power adapter, or power up the unit at
this time.
16/24-Port Plug in the power cord, but do not power up the unit
Clearance Requirements
If you install the IAD horizontally, make sure you maintain at least 2 inches
of horizontal distance from other IADs or other electronic equipment, to
ensure adequate ventilation and heat dissipation. If you install the IAD
- 9 - February 2004