Table of Contents
Advertisement
2000-A2-GB20-10
RFC 1877 DNS Server Assignment for T1/E1, Port 1 is
currently ENABLED
Enter E to Enable, D to Disable:
Type E to enable, or D to disable the DNS server assignment for T1 on
this port.
6. The IAD reports the change, displays the status of the DNS server
assignment for the port, and prompts you to enable or disable it:
RFC 1877 Client configuration unchanged.
Cisco 6400 IP Mask Assignment for T1/E1, Port 1 is
currently ENABLED
Enter E to Enable, D to Disable:
Type E to enable, or D to disable the IP mask assignment for T1 on this
port.
7. The IAD transfers the IP address and mask assigned to a WAN port to
a LAN port.
8. The IAD displays the ATM Service Category Configuration menu:
Figure 4–46. ATM Encapsulation Configuration Menu
*****************************************
ATM Service Category Configuration
*****************************************
Current Encapsulation: NONE
1. CBR
2. UBR
Type 1 to select CBR for high priority data
—or—
Type 2 to select UBR for low priority data.
9. The IAD displays the Peak Cell Rate Configuration menu:
Figure 4–47. ATM PCR Configuration Menu
*******************************************
ATM Peak Cell Rate (PCR) Configuration
******************************************
Current line speed for this interface is 1544000 bps
Please type a PCR value, or
Press ENTER to accept allowed maximum PCR value for
this line speed
Enter Peak Cell Rate (PCR) [3641 cells per second]:
Type the PCR value or press Enter to set the PCR to the maximum
rate for the current line speed.
10. The IAD saves the configuration and displays the ATM PVC
Configuration menu.
- 81 -
February 2004
Advertisement
Table of Contents
