Rear Panel Connectors; Jetfusion 16/24-Port Iad Family - Paradyne JetFusion Integrated Access Device User Manual

JetFusion
16/24-Port
IAD Family
2000-A2-GB20-10

Rear Panel Connectors

On the rear panel (Figure
type and position of the WAN and telephone connectors vary by IAD.
Figure 1–3. Typical 2/4/8-Port Family Back Panel Connectors
Console (DB-9)
Serial Connector
PWR CONSOLE
Power
Ethernet (RJ-45)
Receptacle
DC Power Adapter
Connects the IAD to any AC outlet of 90-250 volts via an external, 18 volt
power supply.
RS-232 Console Port
Connects the IAD to a PC using a straight through 9-pin serial (DB9 RS-
232) cable, for the purpose of using a terminal emulator for IAD
configuration and management.
10/100Base-T Ethernet Port
Connects the IAD to the local area network using a CAT-5 straight through
Ethernet cable, or directly to a PC for accessing via Telnet (using a cross-
over cable, customer-supplied).
WAN Interfaces
Depending on the IAD, WAN interfaces include the following:
‹
T1/E1—uses an RJ48 connector for the connection.
‹
G.SHDSL—uses an RJ11 connector for the connection.
‹
SDSL—uses an RJ45 connector for the connection.
‹
ADSL—uses an RJ45 connector for the connection.
Telephone Interfaces
2/4/8-port IADs have varying telephone capacity. These IADs support:
‹
2, 4, or 8 analog telephones via RJ11 POTS ports
—or—
‹
8 telephone extensions via 4 BRI ISDN S0 ports.
The JetFusion  16/24-port IAD family provides a highly interoperable,
cost-effective broadband solution for voice and high-speed data
integration that is compatible with industry-leading DSLAM and Voice
- 4 -
1–3), the IAD contains several connectors. The
POTS Telephone Lines
RJ-11 Jacks
1 2 3 4
10/100 LAN LINE LINE LINE LINE
LINE 5 LINE 6 LINE 7 LINE 8 WAN
WAN Module
RJ-45 or RJ-48C Jack
February 2004