Table of Contents
Advertisement
Setting
Debug
Mode
Configur-
ing Echo
Cancella-
tion
2000-A2-GB20-10
3
Low Voltage
4
Low Voltage
Press any key to return to the Loop Start Idle Voltage Selection menu.
Enabling and DIsabling Idle High Voltage for a Specific Port
1. Type 3 to enable or disable idle high voltage for a specific port.
2. The IAD displays the port prompt:
Select Line: [1-8]
Type the port number to set.
3. The IAD displays the following prompt:
Enter E to Enable, D to Disable:
Type E to enable idle high voltage, or D to disable it.
4. The IAD saves the mode you've selected and displays the menu.
5. Press Escape to display the Voice Configuration menu and continue
with other voice path configuration.
Reset the IAD
Reset the IAD (page 14) when you finish voice path configuration.
Option M, Set Debug Mode, is reserved for Paradyne network engineers.
To set echo cancellation default settings, type E to display the Echo
Cancellation Default Settings Configuration menu:
Figure 7–9. Echo Cancellation Default Settings Configuration Menu
*****************************************************
Echo Cancellation Default Settings Configure Menu
*****************************************************
1. Set Echo Cancellation default setting for all ports
2. Display current Echo Cancellation default settings
3. Configure Echo Cancellation default setting per port
Type the option for the task to perform. Proceed to the appropriate section.
Enabling and DIsabling Echo Cancellation Globally
1. Type 1 to enable or disable echo cancellation for all ports.
2. The IAD displays the following prompt:
Enter E to Enable, D to Disable:
Type E to enable echo cancellation for all ports, or D to disable it.
3. The IAD saves the mode you've selected and displays the menu.
4. Press Escape to continue with other voice path configuration.
Displaying Echo Cancellation Settings
Type 2 to display the echo cancellation setting on each port.
The IAD displays the following report:
- 134 -
February 2004
Advertisement
Table of Contents
