Table of Contents
Advertisement
2000-A2-GB20-10
‹
Configuring Maintenance Protocol (page 93)
‹
Configuring Congestion Parameters (page 93)
‹
Enabling or Disabling Coppermountain CMCP (page 94)
Selecting Fragmentation Types
To select which fragmentation to use:
1. On the Frame Relay Options menu, type 1 to display the FR
Fragmentation Configuration menu.
Figure 4–61. Frame Relay Fragmentation Configuration Menu
*****************************************
FR Fragmentation Configuration
*****************************************
1. Configure FRF.12 Fragmentation
2. Configure CopperMountain Fragmentation
2. Do one of the following:
a. Type 1 to select Configure FRF.12 Fragmentation—go to FRF.12
Configuration, following.
—or—
b. Type 2 to select CopperMountain Fragmentation—go to
CopperMountain Fragmentation Configuration, on page 92.
Setting FRF.12 Configuration
If you selected FRF.12 Fragmentation, the IAD displays the FRF.12
Configuration menu:
Figure 4–62. FRF.12 Configuration Menu
*****************************************
FR FRF.12 Configuration
*****************************************
1. Enable/Disable FRF.12
2. Enable Automatic Fragment Sizing
3. Set Manual Fragment Size
Type the option and proceed to the corresponding section.
Enabling or Disabling FRF.12
1. Type 1 to enable or disable FRF.12.
The IAD displays the status and a prompt:
FRF.12 Fragmentation is currently DISABLED
Enter E to Enable, D to Disable:
Type E to enable End-to-End fragmentation, or type D to disable it.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page 14) when you finish Frame Relay configuration.
- 91 -
February 2004
Advertisement
Table of Contents
