Setting The Interface To T1 Or E1 - Paradyne JetFusion Integrated Access Device User Manual

Setting the
Interface to
T1 or E1
POWER LAN LINK LAN ACT WAN LINK VOICE
2000-A2-GB20-10
Type the option corresponding to the ATM standard.
6. The IAD sets the standard you select and displays the menu.
7. Reset the IAD (page 14) when you finish WAN configuration.
Using the Debug Menu
NOTE Option D—ADSL Debug Messages—is reserved for
Paradyne network engineers.
To determine the WAN interface setting, or to switch the WAN interface for
use in a T1 (North American) or E1 environment, type 5 (Configure WAN)
on the Main menu to display the WAN Configuration menu for T1/E.
JF2208 This section is for configuring the IAD to use the T1 or E1
JF2216 WAN interface on the JF2208 or JF2216 IAD.
Figure 4–21. WAN Configuration Menu for T1/E1
*****************************************
WAN Configuration Menu
*****************************************
Configuring T1/E1
1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure PVCs
4. Configure ATM Options
1. Type 2 to select Configure Physical Interface.
2. The IAD displays the T1
(Figure 4–23), depending on how your IAD is configured:
Figure 4–22. T1 Configuration Menu
*******************************************
T1 Configuration Menu
*******************************************
1. Select Frame Mode (D4 or ESF)
2. Select Transmit Line Build Out
4. Select B8ZS or AMI
5. Configure Loopback
6. Configure Transmit Channels
7. Configure Receive Channels
8. Configure Transmit Clock Source
9. Change to E1 Mode
- 65 -
(Figure 4–22) or E1 Configuration menu
February 2004