Table of Contents
Advertisement
2000-A2-GB20-10
Type the interface number to configure.
3. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type
1
0
40 RFC 1483 (with LLC Encap)3641
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to configure and press Enter.
4. The IAD displays the IP interfaces on the port you're configuring:
IP interfaces on port 1:
ID
IPAddr
0
91.1.8
IP Over Bridge is enabled
Enter the ID of the interface (0-7) to configure and press Enter.
5. The IAD displays the current IP address and prompts for a new one:
Enter new IP address for this interface:
(91.1.1.18) ->
Type the new IP address and press Enter.
6. The IAD displays the current subnet mask and prompts for a new one:
Current subnet mask = 255.255.255.255
Enter new subnet mask for this interface:
(255.255.255.255) ->
Type the new subnet mask address and press Enter.
7. The IAD prompts you to determine traffic priority on this port:
Select priority Normal/High [N/H] (N):
Do one of the following:
a. Set the interface to high priority—type H.
b. Set the interface to normal priority—type N.
- 99 -
Total = 3641 cps
IPMask
Priority
255.255.255.0
NORMAL
PCR
Service
UBR
February 2004
Advertisement
Table of Contents
