Table of Contents
Advertisement
The NAT
Configuration
Menu
2000-A2-GB20-10
Enabling and managing NAT involves several tasks. These are all
displayed and accessed on the NAT Configuration menu, which you
display by typing N on the Main menu. Tasks in this chapter are described
beginning at the NAT Configuration menu.
Figure 11–1. NAT Configuration Menu
*******************************************
NAT Configuration Menu
*******************************************
B. Enable/Disable NAT Debug Messages
P. Enable/Disable NAT Translation by Port
T. Configure NAT TCP Timeout
U. Configure NAT UDP Timeout
R. Configure NAT Port Range
N. Configure NAT Local Server Entry
A. Configure NAT Alias Entry
S. Display NAT Statistics
C. Display NAT Connection Table
D. Display NAT Connection Details
O. Display NAT Local Server Table
E. Display NAT Alias Table
X. Delete IP Address from NAT Tables
Y. Delete NAT Local Server Entry
Z. Delete NAT Alias Entry
You may sign on as Supervisor or Network Manager to configure NAT.
Options that display in the NAT Configuration menu depend on your
security level. The menu is shown at the Supervisor security level.
NOTE
If you sign on as Network Manager, option B (Enable/Disable
NAT Debug Messages) is not displayed. This option is
reserved for Paradyne network engineers.
Be sure to reset the IAD when you are done making changes
to NAT configuration. Resetting the IAD causes the
configuration changes to take effect.
Table 11–1
lists the default NAT settings.
Table 11–1.NAT Default Parameter Settings
Parameter
NAT Translation by Port
NAT local server entry
NAT TCP Timeout
NAT UDP Timeout
NAT port range—low end
NAT port range—high end
- 170 -
Range
Default
Enabled | Disabled Disabled
1 to 10
1
60 to 3600 seconds 300 seconds
60 to 3600 seconds 120 seconds
5000 to 65534
5000
50000 to 65535
65535
February 2004
Advertisement
Table of Contents
