Paradyne JetFusion Integrated Access Device User Manual page 150

2000-A2-GB20-10
Type the option for the task to perform. Proceed to the appropriate section.
Setting All Ports to Loop Start
1. Type 1 to select Set All Ports to Loop Start.
2. The IAD sets all ports to Loop Start and saves the configuration.
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
5. Reset the IAD (page 14) when you finish voice path configuration.
Setting All Ports to Ground Start
1. Type 2 to select Set All Ports to Ground Start.
2. The IAD sets all ports to Ground Start and saves the configuration.
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
5. Reset the IAD (page 14) when you finish voice path configuration.
Displaying Start Mode
1. To display a list of telephone ports and their current start mode, type 3.
2. The IAD displays a list similar to this:
Port: 1 Mode: Loop Start
Port: 2 Mode: Loop Start
Port: 3 Mode: Loop Start
Port: 4 Mode: Loop Start
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
Configuring Start Mode on an Individual Port
1. Type 4 on the Start Mode Selection menu to select Configure
Individual Port.
2. For each port, the IAD displays the following prompt:
Port 1 [Loop] (1=Lp/2=Grnd/3=DID Wnk/4=E&M Wnk/5=Raw
ABCD/0(or Enter)=NoChange):
3. Type one of the following options for each port:
1—Loop Start
2—Ground Start
3—DID Wnk
4—E&M Wnk
5—RAW ABCD
0 or Enter—no change
4. When you've updated each port, Press Enter a final time.
5. The IAD updates the settings and saves the configuration.
6. Press any key to return to the Start Mode Selection menu. Press
Escape to continue with other voice path configuration.
7. Reset the IAD (page 14) when you finish voice path configuration.
- 131 - February 2004