Interface Statistics Reports - Paradyne JetFusion Integrated Access Device User Manual

Interface
Statistics
Reports
2000-A2-GB20-10
Figure 12–3. Clear Network Statistics Menu
C. Clear ICMP Statistics
G. Clear IGMP Statistics
I. Clear IP Statistics
P. Clear PIM Statistics
T. Clear TCP Statistics
U. Clear UDP Statistics
To permanently reset statistics for a specific protocol, type the option.
The IAD immediately resets all statistics for the specified protocol, and
displays the menu.
Continue resetting network statistics, or press Escape to return to the
Network Statistics menu.
Type I on the Reports menu to display interface statistics reports. The
Interface Statistics menu contains commands to display information about
the packets handled between layer 2 and layer 3 on a per port basis, and
to clear statistics for specific protocols.
To display specific interface statistics, first select an interface and
optionally a port. The IAD then displays the report, as shown in these
steps:
1. The IAD displays the interfaces on this IAD, and a prompt:
Available Interfaces:
1. T1/E1
2. 10/100BaseT Ethernet
0. (Abort)
Type the number of the interface.
2. If there is more than one port, the IAD displays the port list and prompt:
Port DLCI
1 18
Select Port: [1-8]
Type the port number and press Enter.
3. The IAD displays the Interface Statistics menu:
NOTE The commands that display on the Network Statistics menu
vary, based on the WAN module and configuration of the IAD.
Figure 12–4. Interface Statistics Menu (all options shown)
A. Display ARP Statistics
I. Display Interface Statistics
B. Display Bridge Statistics
D. Display DLCI Statistics
Z. Clear a Statistic
Z. Clear ATM PVC Statistics
To display a specific report, type the option.
- 193 -
Encapsulation
Proprietary Voice DLCI
(Ethernet only)
Option D displays "PVC
Statistics" when IAD is
configured for ATM.
February 2004