Table of Contents
Advertisement
2000-A2-GB20-10
This chapter describes the steps to install, connect, and set the IP address
of the JetFusion IAD. It introduces the menu interface and describes how
to perform basic configuration for common LAN and WAN environments. It
also describes basic operations—resetting the IAD, and logging off.
In many cases, all the information you need to get an IAD up and running
in a customer's premises is contained in this single chapter.
This chapter contains the following topics:
‹
Unpacking the IAD (page 9)
‹
Installing the IAD (page 9)
‹
Connecting via Terminal Emulator (page 10)
‹
Resetting the IAD (page 9)
‹
Powering up the IAD (page 10)
‹
Logging on to the IAD (page 11)
‹
Setting the Ethernet port IP address (page 12)
‹
Connecting via Telnet (page 15)
‹
Basic IAD configuration (page 19)
‹
Connecting the LAN, WAN, USI and Telephones (page 19)
‹
Confirming proper setup (page 21)
In most installations, you'll proceed through these topics in order. If your
situation varies, complete information on installation, connection,
configuration and troubleshooting is contained in the reference chapters
following this chapter.
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.
- 8 -
February 2004
Advertisement
Table of Contents
