Basic Router Setup Tasks - Paradyne JetFusion Integrated Access Device User Manual

Basic
Router
Setup
Tasks
2000-A2-GB20-10
To configure the IAD as a router, you should complete the following tasks:
‹
Configure IP addresses on the LAN and WAN ports (page 98)
‹
Enable RIP poisoned reverse (recommended—page 101), add a static
route (page 103), or add a default route (page 105)
‹
Disable bridging globally (page 121) or by port (page 121)
‹
Disable Spanning Tree Protocol (STP) globally (page 123) or by port
(page 123)
Use this flowchart to plan your tasks, based on your router configuration
requirements.
Figure 5–1. Router Configuration Task Flowchart
Configure
Yes
RIP version
by port
Enable RIP
globally
End
- 97 -
Main
Menu
All interfaces
Yes
configured
with IP?
No
Define IP for
each interface
per port
Using
RIP?
No
Using default
route?
Add default
route to
routing table
End
Enable
bridging
interface
per port
Enable
global
bridging
Add static
route to
routing table
End
February 2004