Deleting A Dlci; Displaying Current Dlcis; Configuring Frame Relay Options - Paradyne JetFusion Integrated Access Device User Manual

Configuring
Frame
Relay
Options
2000-A2-GB20-10
16. If you type 2, the IAD displays the fragment size prompt:
Enter maximum fragment size in bytes (100-1600) [0]:
Type the fragment size in bytes and press Enter.
17. The IAD displays the End-to-End Fragmentation Configuration menu.
Press Escape to return to the FR DLCI Config menu.
18. Reset the IAD (page 14) when you finish DLCI configuration.

Deleting a DLCI

To delete a DLCI:
1. On the Frame Relay DLCI Configuration menu, type 3 to select Delete
DLCI.
2. The IAD displays the port list and prompt:
Port DLCI
1 16
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to delete.
a. To permanently remove the DLCI configuration, type y.
b. To cancel the operation, type n.
3. Reset the IAD (page 14) when you finish DLCI configuration.

Displaying Current DLCIs

To display a list of the current DLCIs, type 4 on the Frame Relay DLCI
Configuration menu.
The IAD displays the port list:
Port DLCI
---- -----
1 16
4. Press any key to display the Frame Relay DLCI Configuration menu.
To configure Frame Relay options, type 4 on the WAN Configuration
menu. The IAD displays the Frame Relay menu:
Figure 4–60. Frame Relay Options Menu
*****************************************
Frame Relay Options
*****************************************
1. Configure Fragmentation
2. Configure Maintenance Protocol
3. Configure Congestion Parameters
4. Enable/Disable Coppermountain CMCP
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the Frame
Relay Options menu.
‹
Configuring Fragmentation (following)
- 90 -
Encapsulation
RAW (No Encapsulation)
Encapsulation
-------------
RAW (No Encapsulation)
February 2004