Current Configur-Ation Report - Paradyne JetFusion Integrated Access Device User Manual

Current
Configur-
ation
Report
2000-A2-GB20-10
Most options on the Reports menu generate a specific report. However,
the Network Statistics, Interface Statistics and Media Statistics options
display a menu of several related reports and commands to reset
accumulated statistics.
To display a report or group of reports, or to clear statistics for a particular
protocol or interface, select the option and proceed to the appropriate
section.
NOTE When viewing a report, press any key to display the next
page, or return to the Reports menu at the end of the report.
Press Escape to return to the Reports menu at any time.
To display the Current Configuration report, enter C on the Reports menu.
The Current Configuration report displays configuration settings and
information about the installed interfaces on your IAD.
For each port on the IAD, details are displayed. For each interface
configured on a port, details are also displayed. The parameters are
repeated, and not described again in the table.
The information displayed in the Current Configuration report is listed in
Table 12–1. The contents of this report varies, based on the configuration,
interfaces and ports on the IAD.
Table 12–1. Current Configuration Report
Parameter
Software version
Serial Number
Contains # DSP chip(s)
Routing Information Protocol
Bridging
Bridge Database Aging Time
Spanning Tree
Spanning Tree bridge priority
Spanning Tree hello time
Spanning Tree max age
Spanning Tree forward delay
Simple Network Management
Protocol (SNMP) (IP and EOC)
SNMP System Contact
SNMP System Name
SNMP System Location
SNMP Community
SNMP Trap Host IP Address
Multicasting
- 182 -
Description
version of IAD firmware
serial number of the IAD
no. of DSP chips in the IAD
Status: enabled | disabled globally
Status: enabled | disabled globally
1-3600 seconds (default 300 seconds)
enabled | disabled globally
1-65,535 (default 32,768)
1-10 seconds (default 2 seconds)
6-40 seconds (default 20 seconds)
4-30 seconds (default 15 seconds)
Status: enabled | disabled
user-defined (maximum 39 characters)
user-defined (maximum 39 characters)
user-defined (maximum 39 characters)
name must match the SNMP host (maximum =
39 alphanumeric characters); If SNMP is
enabled and the SNMP Community Name is
null, SNMP goes into read-only mode.
IP address of the SNMP trap host
Status: enabled | disabled
February 2004