Configuring The Adsl Interface - Paradyne JetFusion Integrated Access Device User Manual

Configur-
ing the
ADSL Inter-
face
POWER LAN LINK LAN ACT WAN LINK VOICE
2000-A2-GB20-10
Enter SDSL Auto Cycle Speed Entry to Configure
(1..14):
Type the value of the entry to configure.
3. The IAD prompts for the data rate:
Enter SDSL Data Rate (kbps):
Type the data rate (144 kbps to 2320 kbps, evenly divisible by 8000).
4. The IAD saves the configuration and displays the SDSL Configuration
menu.
Using the Debug Menu
NOTE Commands in option D—SDSL Debug Menu—are reserved
for Paradyne network engineers.
The tasks described in this section all begin on the ADSL Configuration
menu. You should review and update each of these options as necessary,
and reset the IAD when you finish WAN configuration.
To configure the ADSL interface, Type 2 (Configure Physical Interface) on
the WAN Configuration menu to display the ADSL Configuration menu:
JF2004 This section is only for configuring the ADSL WAN interface
JF2008 on the JF2004, JF2008 and JF2004i.
JF2004i
Figure 4–19. G7070 ADSL ATU-R Configuration Menu
*****************************************
G7070 ADSL ATU-R Configuration
*****************************************
1. Set ADSL Standard
D. Enable/Disable ADSL Debug Messages
5. Type 1 to select Set ADSL Standard. The IAD displays the ADSL
Standard menu.
Figure 4–20. ADSL Standard to use for Startup Menu
*****************************************
ADSL Standard to use for Startup
*****************************************
Current ADSL Standard: Multi-Mode
1. T1.413
2. G.LITE
3. G.DMT
4. Alcatel 1.4
5. Multi-Mode
6. ADI
7. Alcatel
- 64 - February 2004