Modifying A Dlci - Paradyne JetFusion Integrated Access Device User Manual

2000-A2-GB20-10
‹
Modifying an Existing DLCI
‹
Deleting a DLCI (Deleting a DLCI
‹
Showing Current DLCIs (page 90)
You may configure up to 8 DLCIs on the IAD.
NOTE Before you configure DLCIs, you must first set the datalink
protocol to Frame Relay. If option 3 on the WAN
Configuration menu displays Configure PVCs instead of
Configure DLCIs, your datalink protocol is set to ATM instead
of Frame Relay.

Modifying a DLCI

To modify a DLCI:
1. On the Frame Relay DLCI Configuration menu, type 2 to select Modify
Existing DLCI.
2. The IAD displays the port list and prompt:
Port DLCI
---- -----
1 16
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to update.
3. The IAD prompts you for the DLCI:
Enter dlci number [16]:
Type the DLCI number to change and press Enter.
4. The remainder of this task is identical to the steps in Adding a DLCI,
following. Proceed to step 3 in the next section and continue.
- 87 -
(Modifying a DLCI
on page 90)
Encapsulation
-------------
RAW (No Encapsulation)
on page 87)
February 2004