Table of Contents
Advertisement
2000-A2-GB20-10
4. Do one of the following.
A. Select Configure Transmit Congestion Parameters and then follow
the on-screen messages to set:
‹
FECN/BECN condition set size
‹
FECN/BECN condition clear size
‹
FECN/BECN max number of bytes to store
—or—
B. Select Configure Receive Congestion Parameters and then follow
the on-screen messages to:
‹
FECN/BECN condition set size
‹
FECN/BECN condition clear size
‹
FECN/BECN max number of bytes to store
5. Reset the IAD (page 14) for changes to take effect.
Enabling or Disabling Coppermountain CMCP
NOTE
When using a CopperMountain DSLAM, CMCP allows the
DSLAM to configure many IAD parameters automatically. IAD
parameters controlled by CMCP include fragmentation and
voice gateway support. For more information, refer the
CopperMountain DSLAM guide.
To enable or disable Coppermountain CMCP:
1. On the Main menu, select Configure WAN to display the WAN
Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
(page 90).
3. Select Enable/Disable CopperMountain CMCP.
The IAD displays the following instructions.
CMCP is currently DISABLED
Enter E to Enable, D to Disable:
4. Do one of the following:
To enable CopperMountain CMCP, type E.
—or—
To disable CopperMountain CMCP, type D.
5. Reset the IAD (page 14) for changes to take effect.
Toggling CMCP Debugging
Option E (Toggle CMCP Debugging) displays when Coppermountain is
selected as a Gateway, and is reserved for use by Paradyne and
Coppermountain network engineers.
This command enables and disables CopperMountain Control Protocol
(CMCP) debugging. You select it once to display the number of
transmitted and received CMCP packets (in bytes). Select it a second time
to disable the display.
- 94 -
February 2004
Advertisement
Table of Contents
