Remove The Adapter - Agilent Technologies 8719ES User Manual

Calibrating for Increased Measurement Accuracy
Adapter Removal Using ECal (ES Analyzers Only)

Remove the Adapter

When the two sets of error correction files have been created (now referred to as
"calibration sets"), the A3 adapter may be removed.
1. Press
MORE
Cal
HELP ADAPT REMOVAL
RECALL CAL SETS
ADAPTER DELAY
ADAPTER COAX
ADAPTER WAVEGUIDE
REMOVE ADAPTER
2. Press
RECALL CAL SETS
RECALL CAL PORT 2
RECALL CAL SETS
file directory.
In the following two steps, calibration data is recalled, not instrument states.
NOTE
3. From the disk directory, choose the file associated with the port 1 error correction, then
press
RECALL CAL PORT 1
4. When this is complete, choose the file for the port 2 error correction and press
RECALL CAL PORT 2
5. When complete, press
6. Enter the value of adapter A3 electrical delay by pressing
entering the value.
7. Select the appropriate key:
8. Press
REMOVE ADAPTER
coefficients and overwrite the current active calibration set in use.
This process uses up an internal memory register. The calibration in this register is not
the calibration created by adapter removal, rather it is a "scratch" calibration. You may
wish to delete the register, or re-save the new calibration in this register as shown in
the following step.
9. To save the results of the new calibration set, press
INTERNAL MEMORY
NOTE Adapter removal can leave a residual state in internal memory. This is not a
valid instrument state and should be deleted.
6-74
ADAPTER REMOVAL
(This Help softkey provides a quick reference guide
to using the adapter removal technique.)
to display
RECALL CAL PORT 1
.
also displays the internal (or external if internal not used) disk
.
.
.
RETURN
ADAPTER COAX
to complete the technique for calculating the new error
RETURN SAVE STATE
to display the following menu:
and
ADAPTER DELAY
or
ADAPTER WAVEGUIDE
Save/Recall
.
and
.
SELECT DISK