Editing An Existing Settings Profile To Remove A Lock - Agilent Technologies WireScope 350 User Manual

4 Press OK when done.
5 Press Start Test to run the Autotest.
1RWH
G‚pxrqÆr‡‡vt†Ãh…rÃqv†ƒyh’rqÐv‡uÃhÃhqy‚pxÃvp‚Ãhy‚tÇurÃ…vtu‡ÃrqtrÂsÇurÃ6ˆ‡‚‡r†‡Ã
Tr‡‡vt†Ã†p…rrÃ…rhpurqÃi’Ã…r††vtÃ6ˆ‡‚‡r†‡ÇurÃƒ…r††vtÃ@qv‡ÃTr‡‡vt†ÃDsÃhÃy‚pxrqÃ
†r‡‡vtÁrrq†Ã‡‚ÃirÃpuhtrqÃrqv‡Ã‡urÃ…‚svyrÃh†Ãqr†p…virqÃiry‚ÃSrhyv“rÇuh‡Ã’‚ˆÃh…rÃ
‰v‚yh‡vtÇurÃr‘v†‡vtÃ…‚svyrÆr‡‡vt†Ã†ryrp‡v‚ÃurÃq‚vtÇuv†
1RWH
XurÃ†ryrp‡vtÃhÆr‡‡vtÃ…‚svyry’ÇurÃy‚pxrqÆr‡‡vt†Ãh…rÆr‡Ãi’ÇurÆryrp‡v‚Ã
Vy‚pxrqÆr‡‡vt†ÃrrqÇ‚ÃirÉr…vsvrqÃh†Ãhƒƒ…‚ƒ…vh‡rÃs‚…ÇurÃr‰v…‚€r‡ÃirvtÇr†‡rq

Editing an Existing Settings Profile to Remove a Lock

You may also edit or delete existing profiles, including the Default
profiles. It is recommended that you do not edit nor delete the Default
profiles, as you must reload the software to get them back in their
original form to meet the standards. To create a profile similar to a
default profile, first select the desired default profile to set the locked
settings. Then create a new profile as described in the next section.
To edit an existing settings profile:
1 In Expert Mode, press Autotest. On the Autotest Settings screen,
1 On the Profile Setup Screen, press the selected profile, then press
2 Change the lock settings by pressing the appropriate boxes. The
press Edit Settings, then press Profile, then press Edit.
Update Selected, then press Next.
check marks toggle with subsequent presses. Then press Next. If the
Test Probe setting is locked, you will see the center screen below,
which will prompt you to select the Performance Grade of the probe
as well as the Probe Test Count Limit, if desired. Then press Next. If
the Test Probe setting is not locked you will go directly to the
@‘ƒr…‡ÃH‚qrÃs‚…Ã8‚ƒƒr…ÃUr†‡vt
UurÃ@‘ƒr…‡Ã6ˆ‡‚‡r†‡ÃTr‡ˆƒ
6−5