Agilent Technologies 8719ES User Manual page 115

3. To move the cursor to the command that you wish to delete, press:
or
• If you wish to scroll through the sequence without executing each line as you do so,
you can press the
• If you use the
commands are actually performed when the cursor points to them. This feature
allows the sequence to be tested one command at a time.
4. To delete the selected command, press:
(backspace key)
5. Press
Seq DONE SEQ MODIFY
Inserting a Command
1. To enter the creation/editing mode, press:
Seq NEW SEQ/MODIFY SEQ
2. To select the particular test sequence you wish to modify (sequence 1 in this example),
press:
SEQUENCE 1 SEQ1
3. To insert a command, move the cursor to the line immediately above the line where you
want to insert a new command, by pressing:
or
• If you use the
commands are actually performed when the cursor points to them. This feature
allows the sequence to be tested one command at a time.
• If you wish to scroll through the sequence without executing each line as you do so,
you can press the
4. To enter the new command, press the corresponding analyzer front panel keys. For
example, if you want to activate the averaging function, press:
Avg AVERAGING ON
5. Press
DONE SEQ MODIFY
Seq
Modifying a Command
1. To enter the creation/editing mode, press:
NEW SEQ/MODIFY SEQ
Preset Seq
2. To select the particular test sequence you wish to modify, (sequence 1 in this example),
press:
SEQUENCE 1 SEQ1
key and scroll through the command list backwards.
key to move the cursor through the list of commands, the
to exit the modify (edit) mode.
key to move the cursor through the list of commands, the
key and scroll through the command list backwards.
to exit the modify (edit) mode.
Making Measurements
Using Test Sequencing
1- 101