Printing, Plotting, and Saving Measurement Results
Saving Measurement Results
Figure 4-13 Data Processing Flow Diagram
If the analyzer has an active two-port measurement calibration, all four
NOTE
S-parameters will be saved with the measurement results. All four
S-parameters may be viewed if the raw data array has been saved.
1. If you want to title the displayed measurement, refer to
Measurement" on page
2. Press
Save/Recall
3. Choose one of the following disk drives:
•
INTERNAL DISK
•
EXTERNAL DISK
"Saving an Instrument State" on page
4. Press
Save/Recall
5. Define the save by selecting from the following choices:
DATA ARRAY ON
RAW ARRAY ON
FORMAT ARY ON
4-40
4-32.
.
SELECT DISK
(If necessary, refer to the external disk setup procedure in
DEFINE DISK-SAVE
"Titling the Displayed
4-38.)
.