Agilent Technologies 8719ES User Manual page 37

Maximum viewing with the LCD display is achieved when primary colors or a
NOTE
combination of them are selected at full brightness (100%).
recommended colors and their corresponding tint numbers.
Table 1-2 Display Colors with Maximum Viewing Angle
Display Color Tint
Red 0
Yellow 17
Green 33
Cyan 50
Blue 67
Magenta 83
White N/A
Color is comprised of three parameters:
• Tint: The continuum of hues on the color wheel, ranging from red, through green and
blue, and back to red.
• Brightness: A measure of the brightness of the color.
• Color: The degree of whiteness of the color. A scale from white to pure color.
The most frequently occurring color deficiency is the inability to distinguish red, yellow,
and green from one another. Confusion between these colors can usually be eliminated by
increasing the brightness between the colors. To accomplish this, press the
softkey and turn the analyzer front panel knob. If additional adjustment
BRIGHTNESS
is needed, vary the degree of whiteness of the color. To accomplish this, press the
softkey and turn the analyzer front panel knob.
Color changes and adjustments remain in effect until changed again in these
NOTE
menus or the analyzer is powered off and then on again. Cycling the power
changes all color adjustments to default values. Once the colors are saved,
pressing the
Saving Modified Colors
To save a modified color set, press
instrument state and are lost unless saved using these softkeys. Once modified colors are
saved, they will be the colors applied until
Recalling Modified Colors
To recall the previously saved color set, press
Brightness
100
100
100
100
100
100
100
key does not affect the color selections.
Preset
SAVE COLORS
Preset
RECALL COLORS
Color
100
100
100
100
100
100
0
. Modified colors are not part of a saved
is pushed.
.
Making Measurements
Using Display Functions
Table 1-2 lists the
COLOR
1- 23