Chapter 1 Overview
Unused pins (for I/O)
Unused I/O pins should be set according to pins' condition at reset. If the output is high impedance (Pch
/ Nch transistor : output off) at reset, to stabilize input, set 10 k to 100 k resistor to be pull-up or pull-
down. If the output is on at reset, set them open.
Output control
Data
Input
Nch
Data
Input
Figure 1-6-3
I - 30
Precautions
10 k to 100 k
Output OFF
Output OFF
10 k to 100 k
Unused I/O pins (high impedance output at reset)
Output control
Output OFF
Data
Input
Output OFF
Nch
Data
Input
10 k to 100 k
10 k to 100 k