Setup Example - Panasonic F77G User Manual

Chapter 11 Serial Interface 0, 1
11-3-8

Setup Example

Transmission / Reception Setup
The setup example at UART transmission / reception with serial 0 is shown.
Table 11-3-33 shows the conditions at transmission / reception.
Table 11-3-33
An example setup procedure, with a description of each step is shown below.
Setup Procedure
(1) Select prescaler operation.
PSCMD (x'3F6F')
bp0 : PSCEN = 1
(2) Select the clock source.
SC0CKS (x'3F97')
bp2-0 : SC0PSC2-0 = 110
(3) Select the used pin.
SC0ODC (x'3F96')
bp7 : SC0SEL = 0
(4) Control the pin type.
SC0ODC (x'3F96')
bp0 : SC0ODC0 = 1
P0PLU (x'3F40')
bp3 : P0PLU3 = 1
(5) Control the pin direction.
P0DIR (x'3F30')
bp4-3 : P0DIR4-3 = 01
XI - 58
Operation
UART Interface Transmision Reception Setup
Setup item
TXD / RXD pin
Frame mode specification
First transfer bit
Clock source
Used pin
TXD0A / RX0DA pin type
Pull-up resistor of TXD0A pin
Parity bit add / check
Serial interface 0 transmission
complete interrupt
Serial interface 0 reception
complete interrupt
set to
independent (with 2 channels)
8 bits + 2 stop bits
MSB
timer 5
A (Port 0)
Nch open-drain
added
"0"add / check
Enable.
Enable.
Description
(1) Set the PSCEN flag of the PSCMD register to
"1" to select prescaler operation.
(2) S e t t h e b p 2 - 0 f l a g o f t h e S C 0 C K S
register to "110" to select timer 4 output as a
clock source.
(3) Set the SC0SEL flag of the
register to "0" to set I/O used pin to A (port 0).
(4) Set the SC0ODC0 flag of the SC0ODC
register to "1" to select N-ch open drain for the
TXD0A pin. Set the P0PLU3 flag of the P0PLU
register to "1" to add pull-up resistor.
(5) Set the P0DIR4-3 flag of the port 0 pin direction
control register (P0DIR) to "01" to set P03 to
output mode, and P04 to input mode.
SC0ODC