Transfer Mode 2 - Panasonic F77G User Manual

Chapter 14 Automatic Transfer Controller

14-3-7 Transfer Mode 2

In transfer mode 2, ATC1 automatically transfers one byte of data from any memory space to the I/O space
(special registers : x'03F00' - x'03FFF') every time an ATC1 activation request occurs.
Set the source address in 18-bit memory pointer 0 (AT1MAP0H, M, L), and set the destination I/O
address in lower 8 bits of memory pointer 1(AT1MAP1L). The upper 10 bits of the I/O space address
(x'03F') need not to be set in AT1MAP1H and AT1MAP1M.
In transfer mode 2, the value in memory pointer 0 increments by 1 each time a byte-length data transfer
ends. As a result, the source address for the next transfer is one address higher than that for the
previous transfer.
Set the data transfer count for ATC1 in the transfer data counter (AT1TRC). The counter can be set to a
maximum of 255 transfers. The counter decrements each time ATC1 is activated. When it reaches x'00',
an interrupt (ATC1IRQ) occurs and the automatic transfer ends.
XIV - 16
Operation
Memory Pointer 0
00000 - 3FFFF
AT1MAP0
(2)
AT1MAP0 + 1
AT1MAP0 + 2
AT1MAP0 + 3
Figure 14-3-4
Memory Pointer 1
03F00 - 03FFF
(1) AT1MAP1
(Only lower
8 bits are valid)
Transfer Mode 2