14-3-17 Transfer Mode C - Panasonic F77G User Manual

Microcomputer mn101c series
Table of Contents

Advertisement

Chapter 14
Automatic Transfer Controller

14-3-17 Transfer Mode C

In transfer mode C, ATC1 automatically transfers one byte of data from any memory space to any other
memory space every time an ATC1 activation request occurs.
Set the source address in 18-bit memory pointer 0 (AT1MAP0H, M, L), and set the destination address
in 18-bit memory pointer 1 (AT1MAP1H, M, L).
In transfer mode C, the values in memory pointers 0 and 1 increment by 1 each time a byte-length data
transfer ends. As a result, the source and destination addresses for the next transfer are one address
higher than those for the original transfer.
Set the data transfer count for ATC1 in the transfer data counter (AT1TRC). The counter can be set to a
maximum of 255 transfers. The counter decrements each time ATC1 is activated. When it reaches x'00',
an interrupt (ATC1IRQ) occurs and the automatic transfer ends.
XIV - 30
Operation
Memory Pointer 0
00000 - 3FFFF
AT1MAP0
(2)
AT1MAP0 + 1
AT1MAP0 + 2
AT1MAP0 + 3
Figure 14-3-14 Transfer Mode C
Memory Pointer 0
00000 - 3FFFF
(1)
AT1MAP1
AT1MAP1 + 1
AT1MAP1 + 2
AT1MAP1 + 3
(2)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Panaxseries mn101c77cPanaxseries mn101f77g

Table of Contents