Panasonic F77G User Manual page 541

Use of PanaX serial writer (DWIRE programming)
You need not to write load program in advance and also be able to use all space of the Flash
EEPROM as user program area.
V pin must supply 5.0 V from external power source.
PP
P53 and P54 pins should be reserved as dedicated pins for serial writer to prevent other
user circuits on the target board from communicating with the device. Alternatively, design your
target board on which the serial writer can program the device correctly.
Connect pull-up resistors on the target board to P53 and P54 pins, which are connected to the
power supply.
NRST and SBT2 pins are output from the serial writer through an open connection.
Install a switch on the target board to toggle between NRST for serial programming and NRST for
normal opeation. Alternatively, install a wired-OR connection. (For a wired-OR connection,
disable NRST for normal operation during serial programming)
You can connect a serial writer easily by setting a 10-wire flat cable on the target board. If a 10-
wire flat cable cannot be mounted to the target board, you can solder it directly.
The signal wire lenghth from the serial writer connector to the microcontroller (NRST, P53 and
P54) must be shorter than 15 cm.
Selection of circuit device on the target board.
Load capacity of reset signal (NRST)
Use the oscillation stabilization wait time right after reset in DWIRE programming. That is, rising
time from reset must be shorter than 1/3 of the oscillation stabilization wait time.
Set as:
Maximun load capacity of reset signal
C =
RST
Pull-up resistor value (P53, P54)
Caluculate the resistor value using following formula. When operating voltage is 3.3 V, appropri-
ate value is over 1.65 k
R =
upMin
the value derived from following formula and
Oscillation stabilization wait time
3 X Pull-up resistor value
Operating voltage (V
Maximum output current of pin (I
)
DD
)
OL
Onboard Serial Interface Programming Mode
Chapter 18 Flash EEPROM
F
XVIII - 17