LEGRAND D45 SYSTEM Installation Manual page 215

Apartment interface
Configuration by inserting phisical configurators - WAY 1:
F F I I #I #I
Code for the configuration place - meaning of the configuration place:
CONFIgUrATION PlACE MODE 1
CF1
FF
CF2
CF3
II
CF4
CF5
CF6
With 4 apartments at each floor and a total of not over 20 floors, you can configure as per MODE 1 (The floor number is from 1 to 20 and the apartment number is from 1 to 4); if not so,
you must use MODE 2 for the configuration.
Configuration examples:
ExAMPlE (A) - Apartment interface there are 20 floors in 323009 unit, with four houses at each floor. When the house number is 1204, 323009 can be configured as per MODE 1.
CONFIgUrATION PlACE CONFIgUrATION vAlUE
CF1
CF2
CF3
CF4
CF5
CF6
ExAMPlE (B) - If the room number is 1206 and the apartment number at each floor is 8, then device must be configured as per MODE 2.
CONFIgUrATION PlACE CONFIgUrATION vAlUE
CF1
CF2
CF3
CF4
CF5
CF6
MODE 2 DIrECTIONS
FF FF is the Device floor number (Tens at the front)
II II means the Device apartment number (Tens at the front)
#If we have four households on each floor (tens at the front): #II is for 0 (or no configuration resistor), the default is 4 households. The
#II
building is 20floors.
rEMArkS
1
FF=12
2
0
II=04
4
0 #II is configured as 0 and the system will default the
house number at each floor as 4.
0
rEMArkS
1
FF=12
2
0
II=06
6
0
#II=08
8
BT00456-b-en
CONFIgUrATION DIAgrAMS
F F
1 2 0 4 0 0
CONFIgUrATION DIAgrAMS
F F
1 2 0 6 0 8
13/05/2013
323009
I I #I #I
I I #I #I
211