Anamorphic Lens Installation - Christie roadie 25k User Manual

Install First Lamp
'

Anamorphic Lens Installation

NOTE: The optional anamorphic lens mount is required for use of the 1.25x
anamorphic lens, producing 2.39:1"scope" images.
If the anamorphic lens will be used, it is recommended that you add the lens—and its
mount—before final leveling, boresight adjustment and the like. Install only for those
installations requiring full-size 2.39:1 "scope" display (mostly side-masking screens)
obtained by optically stretching a pre-squeezed image.
INSTALL THE ANAMORPHIC LENS MOUNT ON THE PROJECTOR:
1.
of the projector, install the anamorphic lens mount hardware as described in
the instructions provided with Christie's Anamorphic Lens Mount Kit.
INSTALL THE 1:25x ANAMORPHIC LENS:
2.
mount in place, following the instructions provided with the anamorphic lens
mount kit.
Qualified service technician required.
Remove the lamp door and open the empty lamp cooling compartment.
Figure 2.19. Open Lamp Door and Cooling Compartment
Install one of the following lamps in the projection head, depending on your model
and site:
Single-or-3-Phase Ballast
* For this projector, the 2.0 kW is available in CDXL (maximum performance) only
** Available as CDXL (maximum performance) or original CXL (less expensive).
(OPTIONAL)
Clamp the 1.25x anamorphic lens
WARNING
Protective gear required.
3-Phase Ballast Required
2.0 kW *
3.0 kW **
Refer to full specifications in Section 6.
INSTALLATION AND SETUP
At the front
4.5 kW **
6.0 kW **
Roadie 25K User's Manual
2-17