Toyota 2GR-FE Manual page 1013

2GR-FE STARTING – STARTER
(d) Install the repair service starter kit with the 2 screws.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
A079719E06
(e) Connect the lead wire to terminal C with the nut.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
A079718E06
INSTALLATION
1. INSTALL STARTER ASSEMBLY
(a) Install the starter assembly with the 2 bolts.
Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf)
(b) Connect the wire harness to terminal 30 and install
the nut. Then, attach the terminal cap.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
(c) Connect the terminal 50 connector to the starter
assembly.
A133864
2. INSTALL NO. 1 AIR CLEANER INLET (See page
49)
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See
page EM-50)
4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See
page ES-506)
5. INSTALL AIR CLEANER INLET ASSEMBLY (See page
EM-50)
6. INSTALL V-BANK COVER SUB-ASSEMBLY (See
page EM-52)
7. INSTALL COOL AIR INTAKE DUCT SEAL (See page
EM-52)
8. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL (See page EM-51)
ST–149
EM-
ST