Toyota 2GR-FE Manual page 1012

ST–148
Groove
Claw
Rubber
Groove
Groove
ST
2GR-FE STARTING – STARTER
4. INSTALL STARTER ARMATURE PLATE
(a) Align the claw of the armature plate with the groove
inside the starter yoke assembly, and install the
starter armature plate.
A073991E14
5. INSTALL STARTER COMMUTATOR END FRAME
ASSEMBLY
(a) Align the starter commutator end frame rubber with
the groove of the starter yoke assembly.
(b) Install the starter commutator end frame assembly
to the starter yoke assembly.
NOTICE:
The magnet of the starter yoke assembly may
attract the starter armature assembly when the
starter commutator end frame assembly is
A079727E08
installed, causing the magnet to break.
6. INSTALL STARTER YOKE ASSEMBLY
(a) Align the claw of the starter yoke with the groove
Claw
inside the motor terminal starter kit.
A079728E07
(b) Install the starter yoke with the 2 through bolts.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
A079720E06
7. INSTALL REPAIR SERVICE STARTER KIT
(a) Apply high-temperature grease to the plunger and
the hook.
(b) Hang the plunger hook of the repair service starter
kit to the drive lever hook.
(c) Install the plunger and the return spring.
A079729E03