Toyota 2GR-FE Manual page 1011

Lock
Free
Snap Ring Pliers
Length
2GR-FE STARTING – STARTER
5. INSPECT MOTOR TERMINAL STARTER KIT
(a) Check the starter clutch.
A081655E05
REASSEMBLY
1. INSTALL PLANETARY GEAR
(a) Apply high-temperature grease to the planetary
Apply Grease
(b) Install the 3 planetary gears to the motor terminal
A081656E06
2. INSTALL STARTER ARMATURE ASSEMBLY
(a) Apply high-temperature grease to the plate washer
(b) Install the starter armature assembly to the starter
(c) Using snap ring pliers, install the plate washer and a
A082440E08
(d) Using vernier calipers, measure the snap ring.
A058810E14
3. INSTALL STARTER COMMUTATOR END FRAME
COVER
(a) Install the starter commutator end frame cover to
A081178E03
(1) Rotate the clutch pinion gear counterclockwise
and check that it turns freely. Try to rotate the
clutch pinion gear clockwise and check that it
locks.
If necessary, replace the motor terminal starter
kit.
gears and pin parts of the planetary shaft.
starter kit.
and the armature shaft.
commutator end frame assembly.
new snap ring.
Maximum length:
5.0 mm (0.197 in.)
If the length is greater than the maximum, replace
the snap ring with a new one.
the starter commutator end frame assembly.
ST–147
ST