Panasonic KX-TD500 System Reference Manual page 1470

4.04 Port Test Results screen (1/3) – (3/3)
Port Test
Slot
1
2
P 3
o 4
r 5
t 6
7
8
P: Pass, 1-F: Fault
=>
1 COMMON 2
Port Test Error Code List
Code Description
1 Loop current failure
2 Bell detection failure
3 PB Generator failure
4 Dial pulse failure
5 PB Receiver 1 failure
6 PB Receiver 2 failure
7 Tone detection circuit 1 failure
8
Tone detection circuit 2 failure
9 HDLC failure
A
OHCA card is not installed
B Pulse detection failure
C Speech path failure
D
PB Receiver 3 failure
E
PB Receiver 4 failure
F
P No errors
Basic Shelf
000000000111
123456789012
- P- - - - - - - - - -
- - P1- - - - - - - P
- - - - - - - - - - - P
- - - - - - - - - - - P
- - - - - - 4- - - - -
- - - - - - - - - - - -
- - - - - - - - - - - -
- - - - - - - - - - - P
3 4
Port
Pair
test test
15-F-10
Tested at 12:05 AM JUL/09/96
Slot 000000000111
123456789012
09 - - - 2- - - - - - - P
10 - - - - - - - - - - - P
P 11
- - - - - - - - - - - P
o 12 - - - 3- - - - - - - P
r 13
- - - - - - - - - - - P
t 14 - - - - - - - - - - - P
15 - - - - - - - - - - - P
16
- - - - - - - - - - - P
5 6 HRD CPY 7
(Note)
If you want to verify the status of the DTMF
receiver, change it's status to "Out of Service" by
entering OUS command and verify the status of a
card which contains DTMF receivers.
SLC, HLC, MSLC, DHLC, ESLC and OPX card
contains DTMF receivers respectively.
For further information about OUS command,
refer to Section 15-C-1.02 "OUS command".
This port test is available only for ports on the
following cards.
LCOT, GCOT, RCOT, PCOT, SLC, MSLC,
DLC, DHLC, ESLC, PLC, HLC, DISA, AGC,
OPX, and ATLC card.
When you test the SLC, HLC, MSLC, OPX, DLC,
DHLC, ESLC, LCOT,GCOT, PCOT and RCOT
cards, change the status of both extension port
and CO port to "OUS".
If a trouble is caused by a card, an error mes-
sage "Card Fault" appears on the screen.
Legend:
: applied, : not applied
ONL TST LIN DIR
8