Connecting Cables; Connecting The Lan Cable; Connecting Usb2.0 Interface Cable; Connecting Power Supply Cable - MIMAKI TS500P-3200 Operation Manual

Connecting Cables

Connecting the LAN cable

When connecting LAN cable, be sure to follow the note
below:
• Directly connect the machine to a PC with a LAN
cable.
• Surely insert LAN cable until clicking noise
sounds.
• Do not plug in or unplug any cable during data
transferring.

Connecting USB2.0 Interface Cable

Connect the PC and this machine with the USB2.0
interface cable.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached to
the PC.
Notes on USB 2.0 Interface
• Since the connection to a LAN cable is
recommended in this machine, the USB2.0
connection may not satisfy the specification of
some print mode.
• Your RIP must be compatible with USB 2.0.
 Notes on peripheral devices in USB high speed
mode
When a peripheral device (USB memory or USB HDD) to
be operated in USB high speed mode is connected to the
same personal computer that a TS500P machine is
connected to, the USB device may not be recognized.
When TS500P is connected to the personal computer to
which an external HDD is connected via USB, the speed
of data output to TS500P may drop.That can cause the
head unit to stop temporarily at the right or left end during
printing.
 Removing USB memory
If a USB memory module is inserted in the personal computer to
which a TS500P machine is connected, click "Stop" in the
"Safely Remove Hardware" window by following the instructions
given there first and then remove the module.
Leaving a USB memory module inserted can cause [ERROR
201 COMMAND ERROR].
Copy the data onto the hard disk before outputting it for printing.
LAN cable
You are not allowed to install the printer by yourself. Be
sure to request MIMAKI's service personnel and an
electrician to install the printer.
USB cable
For power supply connection, this printer uses the Type B plug
and socket in compliance with IEC 60309.
When a socket construction meeting the plug of the power cable
of this printer is required, use the supplied socket and perform
construction between your switchboard and the socket.
Socket construction

Connecting Power Supply Cable

• The power supply specifications of this machine is as
below:
Single-phase 200 to 240 Vac 30 A or less (cannot be
used with 100 V system)
• For the power supply to the main body of the printer,
electrical work is required as described below.
Request an electrician to perform electrical work.
• Socket installation onto the circuit breaker
• Grounding work
• Ensure that a wall outlet is available near the printer.
Also ensure that the power cable can be easily
unplugged whenever necessary.
• To prevent electrical shock hazard, it is prohibited for
anyone other than electrician licensees to perform
the electrical work for this printer.
• Take care not to miswire, which can result in a fire or
an electric shock.
• When any power cable other than the supplied one is
to be used, make sure that the cable is equivalent to
one of the following types. Connect the cable as
shown below.
2
• VCT-5.5m m x33 cores (600 V)
• UL-AWG10x3C (600V)
Side of the
Socket
printer body
Supplied socket
Power cable:
UL AWG10 or the
equivalent
Chapter 1 Before Use
Switchboard
Socket
constructi
Switchboard
Circuit breaker
1φ 200V to 240V 30A
1-9
1
2
2
2
2