Table of Contents
Advertisement
Chapter 1 Before Use
Connecting Power Supply Cable
You are not allowed to install the printer by yourself. Be
sure to request MIMAKI's service personnel and an
electrician to install the printer.
• The power supply specifications of this machine is
as below:
Single-phase 200 to 240 Vac 29A (cannot be used
with 100 V system)
• For the power supply to the main body of the
printer, electrical work is required as described
below. Request an electrician to perform electrical
work.
• Socket installation onto the circuit breaker
• Grounding work
• Ensure that a wall outlet is available near the
printer. Also ensure that the power cable can be
easily unplugged whenever necessary.
• To prevent electrical shock hazard, it is prohibited
for anyone other than electrician licensees to
perform the electrical work for this printer.
• Take care not to miswire, which can result in a fire
or an electric shock.
• When any power cable other than the supplied
one is to be used, make sure that the cable is
equivalent to one of the following types. Connect
the cable as shown below.
2
• VCT-5.5m m
• UL-AWG10x3C (600V)
For power supply connection, this printer uses the Type B
plug and socket in compliance with IEC 60309.
When a socket construction meeting the plug of the power
cable of this printer is required, use the supplied socket
and perform construction between your switchboard and
the socket.
Socket construction
Side of the
printer body
Supplied socket
Power cable:
UL AWG10 or the
equivalent
1-10
x33 cores (600 V)
Switchboard
Socket
Socket
construction
Switchboard
Circuit breaker
1φ 200V to 240V 30A
Fill ink in the ink tank
and charging
Fill ink in the ink tank of this machine.
• Be sure to wear the attached safety goggles and
gloves to perform the work. Ink may get in your
eyes.
Rough standard for adding ink
You can check the current amount of ink in the ink tank of
this machine (rough standard) with the ink remaining
amount indicator below the ink tank.
The way to check the ink remaining amount indicator and
the ink remaining amount are as below.
In addition, when this machine enters into the status of
[Ink Near END] or [Ink End], the display indicate it.
Line of mouth for adding ink
Ink remaining amount indicator
• Notes before adding ink
• Check the following before adding ink. Failure to
do so could require all of the ink inside the ink
supply unit to be discarded.
• Type of ink
• Color of ink
• Expiration date of ink
Check both expiration dates of the ink contained in
the ink bottle for refilling and the ink tank of this
machine.
Check the label for the expiration date of the ink
bottle.
Press the [ENTER] key to check the expiration
date of the ink remaining in the ink tank of this
machine. (
P.3-22)
Advertisement
Table of Contents
