Check Points Of Every 300 Hours; Check Points Of Every 400 Hours - Kubota M5040 Workshop Manual

M5040, M6040, M7040, WSM

[6] CHECK POINTS OF EVERY 300 HOURS

[7] CHECK POINTS OF EVERY 400 HOURS

Replacing Hydraulic Oil Filter
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
Changing Engine Oil
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
Lubricate Grease Fitting (2WD Model)
1. Detach the front wheel hub cover (1), and apply bearing grease.
(1) Front Wheel Hub Cover
Replacing Fuel Filter
1. Remove the fuel filter (1).
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter until it contacts the mounting surface. Tighten
filter by hand an additional 1/2 turn only.
4. Bleed the fuel system. (Refer to "[14] OTHERS" in this section.)
(1) Fuel Filter
Cleaning Water Separator
This job should not be done in the field, but in a clean place.
1. Close the fuel cock (1).
2. Unscrew the retainer ring (2) and remove the cup (3), and rinse
the inside with kerosene.
3. Take out the element (5) and dip it in the kerosene to rinse.
4. After cleaning, reassemble the water separator, keeping out dust
and dirt.
5. Bleed the fuel system. (Refer to "[14] OTHERS" in this section.)
(1) Fuel Cock
(2) Retaining Ring
(3) Cup
(4) O-ring
(5) Element
G-31
G GENERAL
W1072600
W1071704
W1027029
W1026760
(6) Spring
(7) Red Float
(A) Close
W1073022
KiSC issued 06, 2008 A