Kubota M5040 Workshop Manual page 554

M5040, M6040, M7040, WSM
Inner Cover (R.H.)
1. Remove the hand accelerator lever grip (10).
2. Remove the range gear shift lever grip (1).
3. Remove the main shift lever grip (2).
4. Remove the auxiliary control lever grip (4).
5. Remove the PTO control lever grip (5).
6. Remove the position control lever grip (8) and draft control lever
grip (7).
7. Remove the parking brake lever 1 (3) mounting screw (11) from
parking brake lever 2.
8. Pull out the switch board (15).
9. Disconnect the 5P connector (12) from front wiper switch.
10.Disconnect the 3P connector (white) (13) from front working light
switch.
11.Disconnect the 3P connector (blue) (14) from rear working light
switch.
12.Remove the inner cover 2 (9).
13.Disconnect the 2P connector (16) from cigar lighter and remove
the inner cover 1 (R.H.) (6).
(1) Range Gear Shift Lever Grip
(2) Main Shift Lever Grip
(3) Parking Brake Lever 1
(4) Auxiliary Control Lever Grip
(5) PTO Control Lever Grip
(6) Inner Cover (R.H.)
(7) Draft Control Lever Grip
(8) Position Control Lever Grip
(9) Inner Cover 2
Removing Heater Hoses
1. Disconnect the heater hoses (1) and (2).
2. Pull out the heater hoses (1) and (2) from the bottom of the cabin.
3. Take out the heater hoses (1) and (2).
(When reassembling)
• When connecting the heater hose with A/C unit, hose should be
put into the A/C unit pipe more than 30 mm (1.2 in.).
• Be sure to fix the heater hoses (1) and (2) to the original position.
Note the inlet hose and outlet hoses.
(1) Heater Hose 1
10-S46
(10) Hand Accelerator Lever Grip
(11) Screw
(12) 5P Connector (Front Wiper Switch)
(13) 3P Connector
(Front Working Light Switch)
(14) 3P Connector
(Rear Working Light Switch)
(15) Switch Board
(16) 2P Connector (Cigar Lighter)
W1034733
(2) Heater Hose 2
W1030250
KiSC issued 06, 2008 A
CABIN