Kubota M5040 Workshop Manual page 61

M5040, M6040, M7040, WSM
Replacing Fuse (CABIN Model)
1. When inspect the circuit line, check the related fuses.
2. If any of the fuse is blown, replace with a new one of the same
capacity.
IMPORTANT
• If a fuse is blown, check the cause and be sure to replace it
with a new one of the same capacity.
Protected Circuit (Fuse)
Fuse I.D. Capacity (A)
a 5
b 15
c 15
d 10
e 30
f 15
g 15
h 15
i 20
j 20
k 20
l 10
m 10
n 5
o 5
p 15
q 5
r 5
s 20
t 20
Protected Circuit (Slow Blow Fuse)
Fuse I.D. Capacity (A)
a 100
b 50
c 50
d 30
e 30
f 30
g 40
NOTE
• Refer to "5. DISASSEMBLING AND ASSEMBLING" at "9.
ELECTRICAL SYSTEM" for replacing procedure of 100 A
capacity fuse(s) (slow blow fuse).
(1) Fuse Case
(2) Spare Fuse
(3) Fuse Puller
G-39
G GENERAL
Protected circuit
Starter relay
Auxiliary power
Work light (front, side)
Air conditioner (compressor)
Air conditioner (fan motor)
Cigarette lighter
Work light (front)
Work light (rear)
Spare fuse
Flasher (hazard)
Head light, tail lamp
Meter, Radio (back up), Horn
Turn signal, Stop lamp
Meter panel, OPC
Alternator, Engine glow plug
Wiper
Air conditioner (control)
Radio
Rear window defogger
Side window defogger
Protected circuit
Charge
Glow plug
Head light, Hazard
Work light, Fuel cut solenoid
Key switch
Electrical outlet
Air conditioner
[A] Fuse
[B] Slow Blow Fuse
W1054474
KiSC issued 06, 2008 A