M5040, M6040, M7040, WSM
Flywheel Housing
1. Remove the outside flywheel housing mounting screws (2).
2. Set the flywheel housing guide screws (1).
3. Remove the inside flywheel housing mounting screws (3).
4. Remove the flywheel housing.
(When reassembling)
• Apply engine oil to the flywheel housing oil seal (5).
• Set the flywheel housing guide jig (6) to the crankshaft gear (4).
(Refer to "8. SPECIAL TOOLS" at "G. GENERAL" section.)
• Apply a liquid gasket (Three Bond 1217D) to the seam between
crankcase 1 and crankcase 2.
• Assemble the adhesive-applied parts within ten minutes.
Flywheel housing
Tightening torque
mounting screw
(1) Flywheel Housing Guide Screw
(2) Flywheel Housing Mounting Screw
(Outside)
(3) Flywheel Housing Mounting Screw
(Inside)
(4) Crankshaft Gear
1-S45
ENGINE
103.0 to 117.7 N·m
10.5 to 12.0 kgf·m
76.0 to 86.8 lbf·ft
(5) Oil Seal
(6) Jig
(7) Flywheel Housing
(8) Crankcase 1
(9) Crankcase 2
(10) Liquid Gasket
W1034007
KiSC issued 06, 2008 A